September 2017
 << < > >>


Who's Online?

Member: 0
Visitor: 1

rss Syndication


01:48:20 pm

11 Steps to Spray Paint Your Car Like the Professionals - Automobile Bodywork Paint Repair

11 Measures to Spray Paint Your Car Like the Professionals - Auto Bodywork Paint Repair

You may be surprised to find only how you can spray car paint actually can not be difficult. That does not mean that you go at it and can simply grab a tin of paint. There are some basics you have to know. Both in the preparation and application.

Step A:

Prepare by assembling all your things that you are going to need. Be sure your surrounding area is protected against any potential over spray. Any parts that do not need to be sprayed and that can be removed subsequently do so. For other regions cover well with paper and masking tape.

Measure B:

You'll have to analyze the car carefully. In addition, it enables the spray automobile paint to adhere better. Make sure all the dust dirt and debris are removed from the vehicle, once you've finished sanding. It is critical the auto be absolutely clean.

Measure C:

You'll need to apply a primer. This will make sure that you get an overall even coat of your coloured paint plus helps the paint to adhere nicely. Ensure you apply light layers and allow for drying in between, when you spray the primer. How to spray on car paint requires a little getting used to.

Step D:

Now you might be well to the point at which you're around ready to spray the colour. Before you begin with the auto in any case, make several practice strokes on an item. Begin the passes with the paint without reluctance, after you happen to be ready. You may end up getting uneven coverage if you hold the spray can or gun in one place and potentially the paint will run. If it happens you've got an important repair job on your had. You will most likely have directions regarding how you can spray on car paint using the spray or gear cans.

Step E:

Check with someone that is familiar with how to spray car paint, or you may want to research this option on the web

Step F:

You are down to the finishing touches, once you might be absolutely satisfied with the colour. You may now need to apply several coatings that are clear. This can give the gloss and finished look to the auto along with protect the finish. Likely two layers will be satisfactory but it'll be up to you personally. Make absolutely certain it truly is dry in between coats.

Step G:

Once again, you've the choice of wet sanding if you prefer. Again, I suggest you ask the advice of individuals that are comfortable with the way to spray paint a car. If you determine to follow this step then you need to wet sand with the following grits in this arrangement. This will remove Alloy Wheel Repair Essex spots which will not be overly light in the clear coating application.

Step H:

Now you'll want to using a rubbing compound to buff the surface so you could use a 2000 grit to remove any scrapes.

Step I:

You should buff the surface. To try this simply use a moderate cut polish.

Step J:

As a final touch, you may want to apply a number of coats of wax.

Admin · 21234 views · Leave a comment

Permanent link to full entry


No Comment for this post yet...

Leave a comment

New feedback status: Published

Your URL will be displayed.

Please enter the code written in the picture.

Comment text

   (Set cookies for name, e-mail and url)